takoyaki17
Honorary Poster
- Joined
- Feb 27, 2016
- Posts
- 219
- Reaction
- 252
- Points
- 132
FLASHING ROMS TUTORIAL
•this is for Qualcomm device only•
Pre-requisites
*enable Developers Option and enable USB debugging
*The firmware provided here is for Lenovo Legion Phone L79031 ONLY
You do not have permission to view the full content of this post. Log in or register now.
*QFIL
You do not have permission to view the full content of this post. Log in or register now.
*Qualcomm drivers and Lenovo drivers
You do not have permission to view the full content of this post. Log in or register now.
*At least a 50% charge on your device is recommended before installing the firmware.
*You need PC or Laptop.
*Backup using RSA (Rescue and Smart Assistant)
-if you have TWRP Recovery installed on your device, you can create Nandroid Backup through TWRP Recovery
Manual Flashing
1.Download and install Qualcomm/Lenovo USB Driver on your Computer
2.Download and extract Qualcomm Flash Image Loader (QFIL) on your computer.Run as Administrator
3.Click Configuration tab then Firehose Configuration
4.set Device Type to UFS and check Reset After Download
- IMPORTANT!!!leave "Erase all Before Download" UNCHECK then click OK
5.extract Downloaded Firmware
6.back to QFIL... select Meta build
7.click Load Content and browse for content.xml on Extracted Firmware
8.boot into EDL (turn off device, press and hold volume up+down then plug your device using the side port to the computer)
9.you will see on QFIL this "Qualcomm HS-USB QDLoader 9008" if you successfully boot into EDL
10.click Download (wait for it to Finish,it will automatically reset your device)
11. Done
•this is for Qualcomm device only•
Pre-requisites
*enable Developers Option and enable USB debugging
*The firmware provided here is for Lenovo Legion Phone L79031 ONLY
You do not have permission to view the full content of this post. Log in or register now.
*QFIL
You do not have permission to view the full content of this post. Log in or register now.
*Qualcomm drivers and Lenovo drivers
You do not have permission to view the full content of this post. Log in or register now.
*At least a 50% charge on your device is recommended before installing the firmware.
*You need PC or Laptop.
*Backup using RSA (Rescue and Smart Assistant)
-if you have TWRP Recovery installed on your device, you can create Nandroid Backup through TWRP Recovery
Manual Flashing
1.Download and install Qualcomm/Lenovo USB Driver on your Computer
2.Download and extract Qualcomm Flash Image Loader (QFIL) on your computer.Run as Administrator
3.Click Configuration tab then Firehose Configuration
4.set Device Type to UFS and check Reset After Download
- IMPORTANT!!!leave "Erase all Before Download" UNCHECK then click OK
5.extract Downloaded Firmware
6.back to QFIL... select Meta build
7.click Load Content and browse for content.xml on Extracted Firmware
8.boot into EDL (turn off device, press and hold volume up+down then plug your device using the side port to the computer)
9.you will see on QFIL this "Qualcomm HS-USB QDLoader 9008" if you successfully boot into EDL
10.click Download (wait for it to Finish,it will automatically reset your device)
11. Done
Last edited: