Bugger_Shakoy
Honorary Poster
- Joined
- Jul 18, 2015
- Posts
- 253
- Reaction
- 63
- Points
- 147
- Age
- 28
Nakita ko po ito sa reddit regarding sa PLDT SUPERADMIN Access for RP2649 Firmware version. Paki try at feedback nalang po kung gumagana kasi sabi ng poster is napagana niya.
Steps:
1. Unplug the fibr optic cable from the router.
2. Power cycle the router.
3. Go to 192.168.1.1/fh.
4. Type the credentials for adminpldt, no need to access na yung debug switch diretso ka na agad sa adminpldt. Ang ginamit kong credentials ay yung gamit ko rin before.
5. Pag nakapasok ka na, you can plug again the fibr optic cable to your router.
Config your router.
Note: Pag na-log out ka you need to start again from step 1.
Link of the original post from reddit:
You do not have permission to view the full content of this post. Log in or register now.
Steps:
1. Unplug the fibr optic cable from the router.
2. Power cycle the router.
3. Go to 192.168.1.1/fh.
4. Type the credentials for adminpldt, no need to access na yung debug switch diretso ka na agad sa adminpldt. Ang ginamit kong credentials ay yung gamit ko rin before.
5. Pag nakapasok ka na, you can plug again the fibr optic cable to your router.
Config your router.
Note: Pag na-log out ka you need to start again from step 1.
Link of the original post from reddit:
You do not have permission to view the full content of this post. Log in or register now.