Help Pldt R281 boosteven

[coolets02]

Sir/maam magandang araw po, bka pde nyo po ako tulungan ksi di ko n po maaccess ang 192.168.1.1 after ko po ma enable ang bridge mode. Panu ko po yun mababalik ksi sa 192.168.8.1 wla po yung bridge mode po.. salamat po

 

[cyzarine]

same problem. ang ginawa ko noon is tinusok yung reset sa likod. factory reset yan

 

[Xpmove12]

First step muna, kung nakaka connect pa kau sa wifi ssid nyo. At hinde na maka connect sa Gui(Graphic user interface) or dashboard default ip. Kung sa pc or laptop kau, hanapin nyo command prompt type nyo ipconfig/all the press enter magpapakita yung default gateway ip address nyo maari nagbago naging 192.256.259.259

 

[Xpmove12]

Eto pala solusyon mga Sir, Credit kay EugeneKey master pagdating sa R281, CLICK LINK: SEARCH DIN KAU minsan and explore. https://phcorner.net/threads/pldt-h...-openline-di-na-gumagana.1061106/page-2#posts

 

[FrancisAdrian]

Same problem here

Here's how to enable Router Mode in Boosteven R281 (this will also disable Bridge Mode):

1. Turn off the modem.
2. Disconnect your Windows PC/laptop from wired and wireless connection.
3. (For Windows 10) Go to Settings > Network & Internet > Change adapter options (under Advanced network settings) > right-click on Ethernet > Properties > double-click Internet Protocol Version 4 (TCP/IPv4) > then use the following IP address:
   • IP address: 192.168.1.102
   • Subnet mask: 255.255.255.0
   • Default gateway: 192.168.1.1
4. Connect your PC/laptop to the modem in LAN1/WAN.
5. Plug your modem and turn it on. Make sure that none of your wireless devices are going to connect to its wireless network.
6. In a browser, open the configuration page (192.168.1.1). If it works, log-in as usual. Go to Router > Advanced Settings > Router Mode > choose Enabled > (I'm not sure with this one, but the one I chose works for me) select "Modem (preferred) + Ethernet" under "WAN Connection Mode". A pop-up should tell you that your modem is restarting.
7. You may now connect your wireless devices as usual. Also, don't forget to go back to the same thing we did in step 3 (or you may just open the Control Panel window since we already opened it earlier), but this time select "Obtain an IP address automatically". Same goes for the DNS.