Config niyo muna ipv4 niyo > CLICK Start > Control Panel > Network and Internet > Network and Sharing Center > Change Adapter Settings (nasa upper left screen) then hanapin niyo Local Area Connection, right click then PROPERTIES hanapin sa ibaba [Internet Protocol Version 4 (tcp/IPV4) DOUBLE CLICK it, then set niyo the FF:
IP ADDRESS: 192.168.1.100
SUBNET MASK: 255.255.255.0
DEFAULT GATEWAY: 192.168.254.1
then click ok
wait muna kayo few minutes
Tapos Access niyo : 192.168.254.1 sa CHROME if ma open siya
i reset MODEM niyo tapos restart niyo PC niyo, then try to clear the IPV4 configuration after restart if accessible ba ang GUI nang WIMAX
If hindi pa din accessible GUI ng WIMAX after clearing the IPV4 configuration, i config niyo ulit tapos UPGRADE niyo WIMAX niyo sa v30 using Multicast tool
Procedure:
Open Multicast tool
1 Select your network card
2 Set niyo Device BM622i
3 Select the firmware (.bin) extension
4 Click Start
Note: That at this moment wala pang power WIMAX niyo at hindi pa ito naka PLUG sa lan niyo
after clicjking start iuna niyung PLUG ang [LAN SA PC NIYO NEXT, I PLUG ANG WIMAX SA OUTLET]
its ver clear na mauuna munang isaksak ang LAN ng WIMAX sa PC before Ito I POWER ON!
makikita niyong magdidisco LIGHT and WIMAX SIGNAL, wait lang kayo few minutes
if nagstop ang LIGHTS 1,4,5 ng WIMAX it means SUCCESFULL and UPDATE, pwede ng istop ang MULTICAST, then UNPLUG/PLUG YOUR MODEM
if PASTOP-STOP and process tapos humihinto and PAGDIDISCO LIGHT lang WIMAX, FAILED and PROCESS ulitin ulit .
IP ADDRESS: 192.168.1.100
SUBNET MASK: 255.255.255.0
DEFAULT GATEWAY: 192.168.254.1
then click ok
wait muna kayo few minutes
Tapos Access niyo : 192.168.254.1 sa CHROME if ma open siya
i reset MODEM niyo tapos restart niyo PC niyo, then try to clear the IPV4 configuration after restart if accessible ba ang GUI nang WIMAX
If hindi pa din accessible GUI ng WIMAX after clearing the IPV4 configuration, i config niyo ulit tapos UPGRADE niyo WIMAX niyo sa v30 using Multicast tool
Procedure:
Open Multicast tool
1 Select your network card
2 Set niyo Device BM622i
3 Select the firmware (.bin) extension
4 Click Start
Note: That at this moment wala pang power WIMAX niyo at hindi pa ito naka PLUG sa lan niyo
after clicjking start iuna niyung PLUG ang [LAN SA PC NIYO NEXT, I PLUG ANG WIMAX SA OUTLET]
its ver clear na mauuna munang isaksak ang LAN ng WIMAX sa PC before Ito I POWER ON!
makikita niyong magdidisco LIGHT and WIMAX SIGNAL, wait lang kayo few minutes
if nagstop ang LIGHTS 1,4,5 ng WIMAX it means SUCCESFULL and UPDATE, pwede ng istop ang MULTICAST, then UNPLUG/PLUG YOUR MODEM
if PASTOP-STOP and process tapos humihinto and PAGDIDISCO LIGHT lang WIMAX, FAILED and PROCESS ulitin ulit .
Attachments
-
You do not have permission to view the full content of this post. Log in or register now.