Project proposal lang baka may idea kayo salamat po
can i ask some question do have a code for this idea? thank you for respondHello! Sure, I'd be happy to help you come up with a project idea using 2 sensors and monitoring 2 parameters with an Arduino. Here's a proposal for you:
Project Title: Smart Plant Monitoring System
Description:
Create a smart plant monitoring system using an Arduino board, a soil moisture sensor, a temperature and humidity sensor, and an LCD display. This project will help you monitor the soil moisture level and the temperature/humidity of your plants in real-time. You can set thresholds for each parameter, and the system will alert you when the values go beyond the set limits.
Components Needed:
1. Arduino board (e.g., Arduino Uno)
2. Soil moisture sensor
3. Temperature and humidity sensor (e.g., DHT11 or DHT22)
4. LCD display
5. Jumper wires
6. Breadboard
7. Potentiometer (for adjusting LCD contrast)
8. Resistors (if needed)
Project Steps:
1. Connect the soil moisture sensor and the temperature/humidity sensor to the Arduino board using jumper wires.
2. Connect the LCD display to the Arduino board.
3. Write the code to read sensor data and display it on the LCD.
4. Set thresholds for soil moisture level and temperature/humidity values.
5. Implement an alert system to notify the user when the values go beyond the set limits (e.g., using LEDs or buzzer).
6. Test the system by monitoring your plants and observing how the system reacts to changes in soil moisture and temperature/humidity.
This project will not only help you learn about sensor interfacing and programming with Arduino but also allow you to create a practical solution for monitoring the health of your plants. I hope this idea inspires you to get started on your project! If you have any specific questions or need further guidance, feel free to ask. Good luck!
Certainly! Here is a sample code that you can use as a starting point for your Smart Plant Monitoring System project using Arduino, a soil moisture sensor, a temperature and humidity sensor, and an LCD display. Please note that you may need to adjust the code based on the specific sensors and components you are using:can i ask some question do have a code for this idea? thank you for respond
#include <LiquidCrystal.h>
#include <dht.h>
#define DHT11_PIN 2
dht DHT;
const int moistureSensorPin = A0;
const int thresholdMoisture = 500; // Adjust this threshold based on your sensor readings
LiquidCrystal lcd(12, 11, 5, 4, 3, 2);
void setup() {
lcd.begin(16, 2);
lcd.setCursor(0, 0);
lcd.print("Soil Moisture:");
lcd.setCursor(0, 1);
lcd.print("Temp: Humidity:");
}
void loop() {
int soilMoisture = analogRead(moistureSensorPin);
int chk = DHT.read11(DHT11_PIN);
int temperature = DHT.temperature;
int humidity = DHT.humidity;
lcd.setCursor(13, 0);
lcd.print(soilMoisture);
lcd.setCursor(6, 1);
lcd.print(temperature);
lcd.print("C ");
lcd.print(humidity);
lcd.print("%");
if (soilMoisture < thresholdMoisture) {
lcd.setCursor(0, 3);
lcd.print("Water the plant!");
}
delay(1000); // Update readings every second
}
setup()
function, and the sensor readings are displayed on the LCD in the loop()
function.