Closed Hindi ma access ang gui, telnel, at na 169 here are the possible solusyon (for bm622i only)

Config niyo muna ipv4 niyo > CLICK Start > Control Panel > Network and Internet > Network and Sharing Center > Change Adapter Settings (nasa upper left screen) then hanapin niyo Local Area Connection, right click then PROPERTIES hanapin sa ibaba [Internet Protocol Version 4 (tcp/IPV4) DOUBLE CLICK it, then set niyo the FF:


IP ADDRESS: 192.168.1.100
SUBNET MASK: 255.255.255.0
DEFAULT GATEWAY: 192.168.254.1

then click ok
wait muna kayo few minutes

Tapos Access niyo : 192.168.254.1 sa CHROME if ma open siya
i reset MODEM niyo tapos restart niyo PC niyo, then try to clear the IPV4 configuration after restart if accessible ba ang GUI nang WIMAX

If hindi pa din accessible GUI ng WIMAX after clearing the IPV4 configuration, i config niyo ulit tapos UPGRADE niyo WIMAX niyo sa v30 using Multicast tool



Procedure:
Open Multicast tool
1 Select your network card
2 Set niyo Device BM622i
3 Select the firmware (.bin) extension
4 Click Start

Note: That at this moment wala pang power WIMAX niyo at hindi pa ito naka PLUG sa lan niyo

after clicjking start iuna niyung PLUG ang [LAN SA PC NIYO NEXT, I PLUG ANG WIMAX SA OUTLET]

its ver clear na mauuna munang isaksak ang LAN ng WIMAX sa PC before Ito I POWER ON!

makikita niyong magdidisco LIGHT and WIMAX SIGNAL, wait lang kayo few minutes
if nagstop ang LIGHTS 1,4,5 ng WIMAX it means SUCCESFULL and UPDATE, pwede ng istop ang MULTICAST, then UNPLUG/PLUG YOUR MODEM

if PASTOP-STOP and process tapos humihinto and PAGDIDISCO LIGHT lang WIMAX, FAILED and PROCESS ulitin ulit .

tanung ko lang sir pwde pba sa bm622i 2011..?

same old story na rin to. walang ipekto, marami na yan dito sa forum ts.

ok yan, na try ko na dati nag upgrade naman 622i ko

multicast lng b mkakagawa ng 22i? thnks

thanks fot the tut sir. try ko to, blocked ata 622i ko. no signal, no telnet and can't access gui. sana maayos ko dito sa procedure na to. feedback if success. thanks again..

anu ung tinatawag na firmware .bin?

Dear imbz,

Since 2 years have passed since the last reply in this thread, I am locking it to prevent necroposting. Feel free to start a new thread or contact any forum staff if you want this to be reopened.

Thread closed.