Y
Yours
Guest
You do not have permission to view the full content of this post. Log in or register now.
What you need:
*You do not have permission to view the full content of this post. Log in or register now.
*You do not have permission to view the full content of this post. Log in or register now.
*You do not have permission to view the full content of this post. Log in or register now.
*You do not have permission to view the full content of this post. Log in or register now.
*You do not have permission to view the full content of this post. Log in or register now.
*You do not have permission to view the full content of this post. Log in or register now.
Instructions:
Cut two 15×15 squares of cardboard. Brush on PVA glue and glue them together.
Using a wire cutter, cut the hook part of the hanger off.
Straighten the wire to a straight line, using the pliers to help. Curve and bend the wire into an arch. Repeat for the other hanger.
Use a sharp object to pierce the cardboard base at all four corners. You could use the hook part of the hanger if you’d like.
Push the arches into holes diagonal from each other, so the arches from an ‘X’ from the top.
Bend about one inch of the wires inward tape to the bottom of the base.
Pull a small men’s t-shirt over the structure so that the neck hole becomes the ‘entry’ to the tent. Pull taut, and pin the sleeves and back of the t-shirt to the base of the tent.
Place some old fabric fabric/cushion/towel for added comfort.
COMPLETE!
buzzfeed